Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2022ATLAS SEL R-LINEREPAIR AND DIAGNOSISHEATING, VENTILATION & A/C (HVAC)HVAC CONTROL SYSTEMSAIR CONDITIONING87 AIR CONDITIONINGCOMPONENT LOCATION OVERVIEW - A/C SYSTEMCOMPONENT LOCATION OVERVIEW - COMPONENTS INSIDE REAR PASSENGER COMPARTMENT
2022 Volkswagen Atlas SEL R-Line
Component Location Overview - Components Inside Rear Passenger Compartment
2022 Volkswagen Atlas SEL R-LineSECTION Component Location Overview - Components Inside Rear Passenger Compartment
- Nut/Bolt
- 8 Nm
- Bracket
- Refrigerant Line Retainer
- Rear Heater and A/C Unit
- Removing and Installing. Refer to HEATER AND A/C UNIT, REMOVING AND INSTALLING .
- Heater and A/C Unit
- Removing and Installing. Refer to HEATER AND A/C UNIT, REMOVING AND INSTALLING .
- Refrigerant Line Retainer
- Refrigerant Line Retainer
- Condenser with Desiccant Bag
- Overview. Refer to OVERVIEW - CONDENSER .
- Condenser, removing and installing. Refer to CONDENSER, REMOVING AND INSTALLING .
- Desiccant Bag, Removing and Installing. Refer to DESICCANT BAG/DRYER CARTRIDGE, REMOVING AND INSTALLING .
- Seal
- Replace after each removal
- Bolts
- 8 Nm
- For the condenser refrigerant line
- Bolt
- 22 Nm
- Bolt
- 18 Nm
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.