Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Blind Spot Detection Control Module -J1086- / Blind Spot Detection Control Module 2 -J1087-, REMOVING AND INSTALLING: Removing
-- Remove the rear bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .
-- Release the retaining tab -5- from the bracket -2-.
-- Remove the Blind Spot Detection Control Module 2 -J1087- -1- in direction of the -arrow- out of the bracket -2- until the connector -3- is accessible.
-- Release and disconnect the connector -3-.
-- Remove the nuts -4- for the bracket -2-
-- Remove the bracket -2- from the body.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.