Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2019TIGUAN SEL, FWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASREARVIEW CAMERA SYSTEM20 REARVIEW CAMERA SYSTEM20.2 OVERVIEW - REARVIEW CAMERA SYSTEM
2019 Volkswagen Tiguan SEL, FWD
20.2 Overview - Rearview Camera System
2019 Volkswagen Tiguan SEL, FWDSECTION 20.2 Overview - Rearview Camera System
- Radio/Navigation Display Unit Control Module - J503-
- Component location: in the front center console
- Removing and installing. Refer to Communication
- Rearview Camera System Control Module - J772-
- Component location: in the luggage compartment behind the right side trim panel
- Removing and installing. Refer to 20.4 Rearview Camera System Control Module -J772- .
- Rearview Camera - R189-
- Component location: in the rear lid handle button
- Removing and installing. Refer to 20.3 Rearview Camera, Removing and Installing .
- Nut tightening specification: 6 Nm
- Rearview Camera System, Calibrating. Refer to 20.5 Rearview Camera System, Calibrating .
- Steering Angle Sensor - G85-
- Component location: in the steering column electronics control module behind the steering column switch trim panel on the steering wheel
- Steering Column Electronics Control Module, Removing and Installing. Refer to Steering Column Electronics Control Module
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.