Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
46-Pin Connector -T46
2019 Volkswagen Tiguan S, AWDSECTION 46-Pin Connector -T46
46-Pin Connector -T46-
| Cavity | Function |
|---|---|
| 1 | Power (30) |
| 2 | EPB signal (+), left |
| 3 | EPB signal (-), left |
| 4 | Ground RF sensor |
| 5 | Signal (+) RF sensor |
| 6 | Ground LR sensor |
| 7 | Signal (+) LR sensor |
| 8 | Ground LF sensor |
| 9 | Signal (+) LF sensor |
| 10 | Ground RR sensor |
| 11 | Signal (+) RR sensor |
| 12 | Signal (+/-) left motor |
| 13 | Signal (+/-) left motor |
| 14 | Ground (31) |
| 15 | ... |
| 16 | ... |
| 17 | Signal (+) EPB switch 1 |
| 18 | Signal (+) EPB switch 2 |
| 19 | Signal (+) EPB switch 3 |
| 20 | Signal out RR (if equipped) |
| 21 | ... |
| 22 | Signal out RR (if equipped) |
| 23 | Signal (AUTOHOLD), if equipped |
| 24 | Signal (+) EPB switch 4 |
| 25 | ... |
| 26 | Signal OUT right front (if equipped) |
| 27 | ... |
| 28 | Signal OUT left front (if equipped) |
| 29 | ... |
| 30 | Power (30) |
| 31 | Power (30) |
| 32 | Signal (+) AUTOHOLD, if equipped |
| 33 | Signal EPB clutch sensor (if equipped) |
| 34 | ... |
| 35 | Power (15) |
| 36 | Signal (-) EPB |
| 37 | ... |
| 38 | Signal (+) vacuum sensor |
| 39 | Signal EPB (if equipped) |
| 40 | ... |
| 41 | |
| 42 | CAN-H |
| 43 | CAN-L |
| 44 | Power (5V) vacuum sensor |
| 45 | Signal (-) vacuum sensor |
| 46 | Ground (31) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.