Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Without Test Stand For AWD Vehicles
With AWD, testing with standard one-axle dynamometer
-- Drive the vehicle forward onto the rollers.
-- Turn off the engine and wait two seconds.
-- Perform the brake inspection.
-- Start the engine and wait approximately five seconds until there is enough vacuum.
-- Drive the vehicle forward until the rear wheels are standing on the rollers.
-- Turn off the engine and wait two seconds.
-- Perform the brake inspection for the rear brakes.
-- Start the engine and wait approximately five seconds until there is enough vacuum.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.