Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pass-Through Cover Frame, Removing And Installing: Removing
-- Fold down the center armrest and open the pass-through door.
-- Unclip the trim -1- from the rear seat backrest using the :3409 in direction of -arrows-.
-- Use the :T40207 to remove the retaining tabs -2- alternating between the sides.
-- Pry off the cover frame -2- using the :T10039 from the rear seat backrest -1- in direction of -arrow A-.
-- Continue prying off starting at the upper left corner in direction of -arrow B-.
-- Remove the pass-through cover frame.
-- Push the backrest cushion with backrest cover slightly aside, and unclip the pass-through door stop strip -1- from the rear seat backrest in direction of -arrows-.
-- Remove the pass-through door stop strip.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.