Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2016TIGUAN R-LINE, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICES91 COMMUNICATIONDESCRIPTION AND OPERATIONPREMIUM 812-PIN CONNECTOR 4, CD CHANGER -R41- /EXTERNAL AUDIO SOURCE CONNECTION -R199- /MULTIMEDIA SYSTEM CONTROL MODULE -J650
2016 Volkswagen Tiguan R-Line, AWD
12-Pin Connector 4, Cd Changer -R41- /External Audio Source Connection -R199- /Multimedia System Control Module -J650
2016 Volkswagen Tiguan R-Line, AWDSECTION 12-Pin Connector 4, Cd Changer -R41- /External Audio Source Connection -R199- /Multimedia System Control Module -J650
Fig 1: 12-pin Connector 4, CD Changer -R41- /External Audio Source Connection -R199- /Multimedia System Control Module -J650-
- Left audio input (+) External audio source connection -R199- /Multimedia system control module -J650-
- Audio input ground External audio source connection -R199- /Multimedia system control module -J650-
- Audio ground from the CD changer -R41-
- Terminal 30 to the CD changer
- Not assigned
- DATA OUT to CD changer
- Right audio input (+) External audio source connection -R199- /Multimedia system control module -J650-
- Left audio from the CD changer
- Right audio from the CD changer
- Control signal to the CD changer
- DATA IN from the CD changer
- CLOCK from the CD changer
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.