Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Mode 07 - Read Faults Detected During The Current Or Last Driving Cycle: Procedure
-- Connect the scan tool.
-- Start the engine and run at idle.
If the engine does not start, crank the engine using starter for at least 5 seconds. Do not switch the ignition off afterward.
-- Select Mode 7: Check test results of components that are continuously monitored.
The number of pending DTCs or 0 malfunctions detected will be displayed on the scan tool screen.
-- Refer to the following DTC tables for the diagnostic repair procedures.
- ENGINE DTC TABLES, 2016 MY and ENGINE DTC TABLES, 2017 MY
- TRANSMISSION DTC TABLES, 2016 MY and TRANSMISSION DTC TABLES, 2017 MY
-- Switch the ignition off.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.