Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Rearview Camera System Control Module
Control module is installed in luggage compartment behind right side wall trim.
Removing
-- Turn off the ignition and all electrical consumers and remove the key.
-- Remove the right side trim panel in the luggage compartment. Refer to Removal and Installation .
-- Release and disconnect both of the connections -1- and remove the control module -arrow- out of the mount.
Installing
Install in reverse order of removal.
Only if the control module was replaced
-- Calibrate the system again. Refer to REARVIEW CAMERA SYSTEM, CALIBRATING .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.