Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Cellular Telephone Preparation Control Head
Cell phone operating unit is installed above radio or radio navigation system.
Removing
Do the following before starting the procedure:
-- Turn off the ignition and all electrical consumers and remove the key.
-- Remove the storage compartment in the instrument panel. Refer to Removal and Installation .
-- Release the locking mechanism -arrow- in the storage compartment housing.
-- Remove the control head from the housing in the -direction of the arrow-.
-- Disconnect the connector -A- and guide it out of the housing.
Installing
Make sure that the wire connection routing to the control head is trouble-free inside the storage compartments housing.
Install in reverse order of removal.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.