Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Rearview Camera System, Calibrating: Notes
Special tools and workshop equipment required
- Calibration Tool VAS6350
After performing service work on the vehicle, it may be necessary to calibrate the rear view camera system anew. In detail, this is the case after:
- removing and installing rear view camera
- replacing the rearview camera system control module
- after repair work performed on rear lid following an accident
- the standing height of one axle changes by more than 5 mm
- the standing height of the entire vehicle changes by more than 10 mm.
There is some work, which must be performed, before performing the actual calibration. Use the Vehicle Diagnostic Tester as described in the following.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.