Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2016CC R-LINE EXECUTIVE, 2.0L ENG VIN NREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTENTERTAINMENT SYSTEMSCOMMUNICATION91 COMMUNICATIONDESCRIPTION AND OPERATIONREARVIEW CAMERA SYSTEM COMPONENT LOCATION OVERVIEW
2016 Volkswagen CC R-Line Executive, 2.0L Eng VIN N
Rearview Camera System Component Location Overview
2016 Volkswagen CC R-Line Executive, 2.0L Eng VIN NSECTION Rearview Camera System Component Location Overview
- Radio/Navigation Display Control Module -J503-
- Also called the Radio/RNS -RX1-.
- Component location: in center console, front.
- Removing and installing, refer to RADIO/NAVIGATION SYSTEMS -R- / -J503- .
- Rearview Camera System Control Module -J772-
- Component location: in the luggage compartment behind the right trim panel.
- Removing and installing, refer to REARVIEW CAMERA SYSTEM CONTROL MODULE J772 .
- Rear view camera control module, coding, refer to REARVIEW CAMERA SYSTEM CONTROL MODULE J772, CODING .
- Pivoting Emblem With The Rear View Camera -R189- and Pivoting Motor
- Component location: in rear lid.
- Pivoting emblem bolts in rear lid tightening specification: 4 Nm.
- Tightening specification for rear view camera housing and pivoting motor bolts in pivoting emblem: 2.5 Nm.
- Tightening specification for rear view camera housing bolts to pivoting motor: 1.6 Nm.
- Pivoting emblem with rear view camera housing and pivoting motor in rear lid, removing and installing, refer to REARVIEW CAMERA -R189- .
- Rear view camera housing with pivoting motor in pivoting emblem, removing and installing, refer to Rear View Camera Housing with Pivoting Motor in Pivoting Emblem, Removing and Installing .
- Rear view camera, disconnecting from pivoting motor, refer to Rear View Camera, Disconnecting from Pivoting Motor .
- Rear view camera system, calibrating, refer to REARVIEW CAMERA SYSTEM, CALIBRATING .
- Steering Angle Sensor -G85-
- Component location: in the steering column switch trim, behind the steering wheel.
- Removing and installing, refer to Removal and Installation .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.