Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
IPOD BASEPLATE -R192
The iPod baseplate is inside the center console.
Removing
- Turn off the ignition and all electrical consumers.
- Remove the key.
-- Open the center armrest.
-- Reach into the iPod baseplate and remove it in -direction of arrow-.
-- Disconnect the connector under the iPod baseplate.
Installing
-- Connect electrical connector.
-- Insert the iPod baseplate -R192- -A- into the center console and push it in direction -B- until it locks into place.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.