Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2013JETTA GLI, 2.0L ENG VIN 6, STANDARD TRANSREPAIR AND DIAGNOSISHEATING, VENTILATION & A/C (HVAC)GENERAL SERVICINGAIR CONDITIONING (SEDAN)87 AIR CONDITIONINGDESCRIPTION AND OPERATIONREFRIGERANT CIRCUIT COMPONENTS OVERVIEW
2013 Volkswagen Jetta GLI, 2.0L Eng VIN 6, Standard Trans
Refrigerant Circuit Components Overview
2013 Volkswagen Jetta GLI, 2.0L Eng VIN 6, Standard TransSECTION Refrigerant Circuit Components Overview
- Condenser
- Removing and installing, refer to .
- A/C Compressor
- Pay attention to notes for installing A/C compressor, refer to A/C COMPRESSOR, INSTALLATION INFORMATION .
- Removing and installing, refer to A/C COMPRESSOR .
- Hex Head Nut
- 6 Nm
- Bracket
- High Pressure Sensor -G65-
- Removing, refer to High Pressure Sensor -G65- .
- Expansion Valve
- Function and removal, refer to EXPANSION VALVE .
- Evacuating and Charging Valve
- Low pressure side.
- Environmentally hazardous draining of refrigerant is an offense punishable by law.
- Capacities, refer to SPECIFICATIONS .
- Evacuating and Charging Valve
- High pressure side
- Environmentally hazardous draining of refrigerant is an offense punishable by law.
- Capacities, refer to SPECIFICATIONS .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.