Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Climatronic Control Module -J255- MULTI-PIN HARNESS CONNECTORS
Special tools and workshop equipment requiredΒ
- Test Box Kit - Adapter 47VAG1598/47
Connector -A- 20-pin, in wiring diagram T20c
1 -
Sunlight Photo Sensor 2 -G134- or Sunlight Photo Sensor -G107-, signal
2 -
High Pressure Sensor -G65-
3 -
Sunlight Photo Sensor 2 -G134- or Sunlight Photo Sensor -G107-, signal
5 -
CAN High
6 -
CAN Low
9 -
+ 5V for Sunlight Photo Sensor 2 -G134- or Sunlight Photo Sensor -G107-
16 -
Plus connection (15a) in vehicles with auxiliary heater
17 -
Signal Ground (GND) for sensors
18 -
A/C Compressor Regulator Valve -N280-
20 -
Plus connection (15a); in vehicles with auxiliary heater plus connection (30a)
Connector -B- 16-pin harness, in wiring diagram T16g
1 -
+ 5V for motors
2 -
Left Temperature Door Potentiometer/Actuator -G220-
3 -
Right Temperature Door Potentiometer/Actuator -G221-
4 -
Defroster Door Motor Position Sensor -G135-
5 -
Central Door Motor Position Sensor -G112-
6 -
Recirculation Door Motor Position Sensor -G143-
7 -
Back Pressure Door Motor Position Sensor -G113-
8 -
Left Footwell Vent Temperature Sensor -G261-
9 -
Right Footwell Vent Temperature Sensor -G262-
10 -
Fresh Air Intake Duct Temperature Sensor -G89-
11 -
Evaporator Temperature Sensor -G308-
14 -
Signal Ground (GND) potentiometer
15 -
Left Vent Temperature Sensor -G150-
16 -
Right Vent Temperature Sensor -G151-
Connector -C- 16-pin harness, in wiring diagram T16f
1 -
Left Temperature Door Motor -V158-, cold
2 -
Left Temperature Door Motor -V158-, warm
3 -
Defroster Door Motor -V107-, closed
4 -
Defroster Door Motor -V107-, open
5 -
Central Air Door Motor -V70-, upper body vent
6 -
Central Air Door Motor -V70-, footwell
7 -
Fresh/Recirculation Air Door Motor -V154-, activation fresh/recirculated air door motor
8 -
Fresh/Recirculation Air Door Motor -V154-, activation fresh air
9 -
Back Pressure Door Motor -V71-, open
10 -
Back Pressure Door Motor -V71-, close
11 -
Right Temperature Door Motor -V159-, cold
12 -
Right Temperature Door Motor -V159-, warm
15 -
Fresh Air Blower -V2- (PWM activation)
16 -
Fresh Air Blower -V2-, return message signal
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.