Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Mode 04 - Erase DTC Memory
Diagnostic Mode 04 makes it possible to erase the DTC memory and to reset all emissions-related diagnostic data. In that way, all faults in the DTC memory in the ECM and TCM are erased. The adaptation values may also be reset.
Emissions-Related Diagnostic Data Includes (As Applicable):
- -MIL Status
- -Number of DTCs
- -Readiness bits
- -Confirmed DTCs
- -Pending DTCs
- -DTC that belongs to freeze frame
- -Freeze frame data
- -Test results of specific diagnostic functions
- -Distance driven with "MIL ON"
- -Number of warm-up cycles after erasing the DTC memory
- -Distance driven after erasing the DTC memory
- -Misfire counter
Depending on scan tool and protocol used, diagnostic mode 04 and the information provided may be referred to by a different name.
Procedure
-- Connect the scan tool.
-- Switch the ignition on.
-- Select Diagnostic Mode 03: Interrogating fault memory.
-- Then select Mode 4: Reset/delete diagnostic data.
The scan tool will display: Diagnostic data are being erased.
-- Switch the ignition off.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.