Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Service Interval Display, RECODING
-- Connect the Vehicle Diagnostic Tester. Refer to VEHICLE DIAGNOSTIC TESTER, CONNECTING .
-- Switch on the ignition.
-- Touch: "Guided Functions" on the touch screen.
If the displays indicated in the procedure are not shown on the display. Refer to Operating Instructions for Vehicle Diagnostic Tester
-- Select the following one after the other:
- Brand
- Type
- Model year
- Engine code
-- Confirm the VIN.
-- Select the following one after the other:
- "Instrument Cluster"
- "Adapt service interval extension."
-- Adapting according to "Guided Functions".
End Adaptation
-- Select Go to and then press End .
-- Turn off the ignition and disconnect the diagnostic connector.
Change in the Km-Maximum Values for Oil Change Service (fixed) during the Delivery Inspection.
-- Connect the Vehicle Diagnostic Tester. Refer to VEHICLE DIAGNOSTIC TESTER, CONNECTING .
-- Switch on the ignition.
-- Touch: "Guided Functions" on the touch screen.
If the displays indicated in the procedure are not shown on the display. Refer to Operating Instructions for Vehicle Diagnostic Tester
-- Select the following one after the other:
- Brand
- Type
- Model year
- Engine code
-- Confirm the VIN.
-- Select the following one after the other:
- "Instrument Cluster"
- "Identify control module"
- "Guided functions"
- "Oil change service (fixed)"
-- Follow the "Guided Functions" instructions.
-- "1" Reset Oil change service (fixed).
-- Follow the "Guided Functions" instructions.
The maximum Km values are displayed in the Vehicle Diagnostic Tester.
-- Select "no".
-- Select the country specific maximum values until the next oil change service.
-- Adapting according to "Guided Functions".
End Adaptation
-- Select Go to and then press End .
-- Turn off the ignition and disconnect the diagnostic connector.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.