Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Vehicle Positioning System Control Module
The Vehicle Positioning System Control Module -J895- is located behind the left luggage compartment side trim.
Removing
-- Turn off the ignition and all electrical consumers and remove the ignition key.
-- Remove the luggage compartment left trim panel, refer to Removal and Installation .
-- Remove the screws -3 and 4- and remove the Vehicle Positioning System Control Module -J895- -1- from the bracket -2-.
-- Release and disconnect the connectors from the Vehicle Positioning System Control Module -J895- -1-.
Installing
Install in reverse order of removal.
Torque Specifications:
- Screw -3- : 2.5 Nm
- Bolt -4- : 4 Nm
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.