Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2012JETTA TDI, 4D WAGON, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 63 (COMMUNICATION (SEDAN))91 COMMUNICATIONDESCRIPTION AND OPERATIONNAVIGATION SYSTEM CONNECTOR ASSIGNMENTSRNS 510NOTES
2012 Volkswagen Jetta TDI, 4D Wagon, Standard Trans
RNS 510: Notes
2012 Volkswagen Jetta TDI, 4D Wagon, Standard TransSECTION Notes
WARNING: This page is about a different variant/trim than selected.
- Navigation Connection, Japan
- Not Assigned
- Antenna Connection
- DAB
- Antenna systems, refer to ANTENNA SYSTEMS .
- 8-Pin Connector 1, Speaker Outputs
- Terminal assignment 8-Pin Connector 1, Speaker Outputs
- 8-Pin Connector 2, CAN Bus, Voltage Supply
- Terminal assignment 8-Pin Connector 2, CAN Bus, Voltage Supply
- 12-Pin Connector 3, Telephone
- Terminal assignment 12-Pin Connector 3, Telephone
- 12-pin Connector 4, External Audio Source Connection -R199-, Multimedia System Control Module -J650-
- 26-Pin Connector 5, Video and LF Input
- Terminal assignment 26-Pin Connector 5, Video and LF Input
- Antenna Connection GPS Antenna -R50-
- GPS
- Antenna systems, refer to ANTENNA SYSTEMS .
- Antenna Connection
- FM2
- Antenna systems, refer to ANTENNA SYSTEMS .
- Antenna Connection
- AM/FM
- Antenna systems, refer to ANTENNA SYSTEMS .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.