Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2012JETTA TDI, 4D WAGON, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 60 (INTERIOR TRIM (SEDAN))70 INTERIOR TRIMSPECIFICATIONS
2012 Volkswagen Jetta TDI, 4D Wagon, Standard Trans
70 Interior Trim: Specifications
2012 Volkswagen Jetta TDI, 4D Wagon, Standard TransSECTION Specifications
WARNING: This page is about a different variant/trim than selected.
Tightening Specifications
| Component | Bolt Size | Nm |
|---|---|---|
| Driver side deformation element bolts (USA only) | - | 1.5 |
| Front door trim panel bracket bolts | - | 4 |
| High voltage battery cover bracket screws (hybrid) | - | 3.5 |
| Inner wheel housing trim screw (vehicles without side airbag) | - | 2.5 |
| Inner wheel housing trim nut (vehicles without side airbag) | - | 8 |
| Instrument panel central tube bolt to center tunnel | - | 20 |
| Instrument panel central tube nut to mount with extensor | - | 20 |
| Lower door panel bolt | - | 2 |
| Luggage compartment tie down bolts | - | 20 |
| Rear lid trim screws | - | 2 |
| Upper B-pillar trim screw | - | 4 |
| Upper door panel bolts | - | 4 |
| Upper drivers side instrument panel central tube nuts | - | 9 |
| Upper instrument panel central tube bolt (located inside left side of plenum chamber) | - | 20 |
| Upper passenger side instrument panel central tube nuts | - | 4.5 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.