Disassembling The Transmission: Notes

2012 Volkswagen Jetta TDI, 4D Wagon, Standard TransSECTION Notes
WARNING: This page is about a different variant/trim than selected.

Special tools and workshop equipment requiredΒ 

  • Holding Fixture VW 313
  • Press Plate VW 401
  • Press Plate VW 402
  • Press Piece - Rod VW 412
  • Gearbox Support 3221 (modified Check the Gearbox Support 3221 and if necessary modifyΒ ) or
  • Gearbox Support 3221 A
  • Guide Bolt T10079
  • Not needed: Press Piece - 31.5mm VW 418 A
  • Punch VW 407
  • Thrust Pad 3074
  • Press Piece T10080
  • Thrust Block T10083
  • Press Piece - Block - Washer T10083/1
  • Drip Tray V.A.G 1306
  • Press Piece T10085
  • Sealing Paste AMV 188 200 03
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.