Special Tools

2012 Volkswagen Jetta TDI, 4D Wagon, Standard TransSECTION Special Tools
WARNING: This page is about a different variant/trim than selected.

Special Tools And Workshop Equipment Required 

  • Setting Gauge T10173
    Fig 1: Identifying Adjustment Fixture T10173
    GWWW00-1308Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
  • Tensioning Strap T10038
    Fig 2: Identifying Special Tools -- Tensioning Belt T10038
    GWWW00-1005Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
  • Engine Support Bridge 10 - 222 A
    Fig 3: Identifying 10-222A Engine Support Bridge With 10-222A/8 Bracket For Engine
    GWWW00-0225Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
  • Hose Clamps Up to 25 mm Dia.3094
    Fig 4: Identifying 3094 Hose Clamps
    GWWW00-0079Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
  • Engine Support Basic Set T40091
    Fig 5: Identifying Engine Support Basic Set T40091
    GWWW00-10277Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
Fig 6: Identifying Special Tools -- ATF Level, Checking
GWWW37-10020Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Special Tools And Workshop Equipment Required 

  • Torque Wrench (5-50 Nm) V.A.G 1331
  • Used Oil Collecting and Extracting Device V.A.G 1782
  • Vehicle Diagnosis, Testing and Information System VAS 5051
  • Drip Tray for VAS 6100 VAS 6208
  • Adapter for Oil Filling VAS 6262
  • Adapter for Filling ATF Oil VAS 6262/2
Fig 7: Identifying Special Tools -- Transmission, Removing (1 Of 2)
GWWW37-10024Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Special Tools And Workshop Equipment Required 

  • Engine/Transmission Jack V.A.G 1383 A
  • Socket SW15V/175
  • Transmission Support 3282
  • Wedge Tool T10161
  • Torque Wrench (40-200 Nm) V.A.G 1332
  • Adjusting Plate - 09D Trans.3282 /36
Fig 8: Identifying Special Tools -- Transmission, Removing (2 Of 2)
GWWW37-10025Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Special Tools And Workshop Equipment Required 

  • Engine Support Bridge 10 - 222 A
  • Engine Support Feet 10 - 222 A/8
  • Adapter 10 - 222 A/7
  • Bracket with Spindle and Hook 10 - 222 A/10
  • Engine Support Adapter 10 - 222 A/3
  • Shackle10 - 222 A/12
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.