Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2012JETTA TDI, 4D SEDAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 63 (COMMUNICATION (SPORTWAGEN))91 COMMUNICATIONSPECIFICATIONSCELLULAR TELEPHONE AND TWO-WAY RADIOS, TRANSMITTED OUTPUT, ANTENNA INSTALLATION LOCATIONS
2012 Volkswagen Jetta TDI, 4D Sedan, Standard Trans
Cellular Telephone And Two-Way Radios, Transmitted Output, Antenna Installation Locations
2012 Volkswagen Jetta TDI, 4D Sedan, Standard TransSECTION Cellular Telephone And Two-Way Radios, Transmitted Output, Antenna Installation Locations
WARNING: This page is about a different variant/trim than selected.
| Designation | Pmax/Watt | Prescribed antenna installation locations | ||||
|---|---|---|---|---|---|---|
| Shortwave < 54 MHZ | 100 (PEAK)(1) | Front center of roof Center of roof Rear center of roof Rear bumper | ||||
| 4 m-Band | 20 (eff.)(2) | All locations on vehicle exterior | ||||
| 2 m-Band | 20 (eff.) | Front fender Front center of roof | ||||
| 2 m-Band | 50 (eff.) | Center of the roof center of the roof at the rear fender | ||||
| 70 cm | 50 (eff.) | Front center of roof Center of roof Rear center of roof | ||||
| 23 cm | 20 (eff.) | All locations on vehicle exterior | ||||
| TETRA/TETRAPOL | 25 (eff.) | All locations on vehicle exterior | ||||
| D-network/GSM 900 | 20 (Peak) | All locations on vehicle exterior | ||||
| E-Network/GSM 1800 GSM 1900/UMTS | 10 (Peak) | All locations on vehicle exterior | ||||
|
||||||
Deviations from these guidelines (location of antenna, frequency, output) are only permitted in special isolated cases after a single-case test carried out by the EMV center of VW AG in Wolfsburg.
EMV = Electromagnetic Compatibility.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.