Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
In Center Console
Special tools and workshop equipment required
- Radio Removal Tool T10057
Removal
- Turn off the ignition and all electrical consumers.
- Remove the key.
-- Disconnect any devices connected to the multimedia system control module.
-- Insert the VAS 3316 into the slots on the multimedia system control module -1- until it audibly engages.
-- Pull the multimedia system control module -1- out of the center console -2- using the T10057.
-- Disconnect the connector -arrow- -A- on the multimedia system control module.
-- Press the clips on the multimedia system control module and remove the VAS 3316 at the same time.
Installation
Install in reverse order of removal.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.