SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2012JETTA TDI, 4D SEDAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 63 (COMMUNICATION (SPORTWAGEN))91 COMMUNICATIONREMOVAL AND INSTALLATIONCD CHANGER -R41
2012 Volkswagen Jetta TDI, 4D Sedan, Standard Trans

Cd Changer -R41

2012 Volkswagen Jetta TDI, 4D Sedan, Standard TransSECTION Cd Changer -R41
WARNING: This page is about a different variant/trim than selected.

Special tools and workshop equipment required 

  • Radio Removal Tool VAS 3316

The CD changer is inside the center console.

Removing 

CAUTION:
  • Turn off the ignition and all electrical consumers.
  • Remove the key.

-- Open the center armrest.

-- If there is a CD still in the player, remove it. Refer to the Owner's Manual.

-- Insert the VAS 3316 into the slot on both sides of the CD changer until they click into place.

-- Remove the CD changer using the VAS 3316 -arrows-.

Fig 1: Identifying Removal Of CD Changer Using Radio Release Tools
GWWN91-10005Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connectors marked with -arrows-.

Fig 2: Identifying Electrical Connection Locks
GWWN91-10004Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press on the locking clip -arrow- and pull out the VAS 3316.

Fig 3: Identifying Retaining Clip - Arrow - To Remove Release Tools
GWWN91-10003Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Installing 

Install in reverse order of removal.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.