SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2012JETTA TDI, 4D SEDAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 65 (MAINTENANCE PROCEDURES (CONVERTIBLE))03 MAINTENANCE, DIAGNOSISMAINTENANCE PROCEDURESSERVICE INTERVAL DISPLAY, RECODING
2012 Volkswagen Jetta TDI, 4D Sedan, Standard Trans

Service Interval Display, RECODING

2012 Volkswagen Jetta TDI, 4D Sedan, Standard TransSECTION Service Interval Display, RECODING
WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Connect the Vehicle diagnostic Tester. Refer to Vehicle Diagnostic Tester .

-- Switch on the ignition.

-- Touch: "Guided Functions" on the touch screen.

NOTE:

If the displays indicated in the procedure are not shown on the display. Refer to Operating Instructions for Vehicle Diagnostic Tester

-- Select the following one after the other:

  • Brand
  • Type
  • Model year
  • Engine code

-- Confirm the VIN.

-- Select the following one after the other:

  • "Instrument Cluster"
  • "Adapt service interval extension."

-- Adapting according to "Guided Functions".

End Adaptation

-- Select Go to  and then press End  .

-- Turn off the ignition and disconnect the diagnostic connector.

Change in the Km-Maximum Values for Oil Change Service (fixed) during the Delivery Inspection.

-- Connect the Vehicle diagnostic Tester. Refer to Vehicle Diagnostic Tester .

-- Switch on the ignition.

-- Touch: "Guided Functions" on the touch screen.

NOTE:

If the displays indicated in the procedure are not shown on the display. Refer to Operating Instructions for Vehicle Diagnostic Tester

-- Select the following one after the other:

  • Brand
  • Type
  • Model year
  • Engine code

-- Confirm the VIN.

-- Select the following one after the other:

  • "Instrument Cluster"
  • "Identify control module"
  • "Guided functions"
  • "Oil change service (fixed)"

-- Follow the "Guided Functions" instructions.

-- "1" Reset Oil change service (fixed).

-- Follow the "Guided Functions" instructions.

The maximum Km values are displayed in the Vehicle Diagnostic Tester.

-- Select "no".

-- Select the country specific maximum values until the next oil change service.

-- Adapting according to "Guided Functions".

End Adaptation

-- Select Go to  and then press End  .

-- Turn off the ignition and disconnect the diagnostic connector.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.