Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2012JETTA TDI, 4D SEDAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 190 (CONTROLS, HOUSING - MANUAL TRANSMISSION 02Q (HATCHBACK))34 CONTROLS, HOUSINGDISASSEMBLY AND ASSEMBLYTRANSMISSIONASSEMBLYNOTES
2012 Volkswagen Jetta TDI, 4D Sedan, Standard Trans
Disassembly And Assembly: Transmission: Assembly: Notes
2012 Volkswagen Jetta TDI, 4D Sedan, Standard TransSECTION Notes
WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Holding Plate VW 309
- Holding Fixture VW 313
- Transmission Support VW 353
- Thrust Tube VW 455
- Sleeve 3160
- Slide Hammer-Complete Set VW 771
- Kukko Puller 12-14.5 mm 21/1
- Kukko Separating Tool 5-60 mm 17/0
- Kukko Support 22/1
- Bracket 30-211 A
- Thrust Piece T10143
- Press Tool for Shaft Seal T10180
- Drift T10169 or T10362
- Thrust Piece T40008
- Torque Wrench (5-50 Nm) V.A.G 1331
- Inductive Heat Unit V.A.G 1416
- Drip Tray for VAS 6100 VAS 6208
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.