Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSVOLKSWAGEN2012JETTA TDI, 4D SEDAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 175 (MANUAL TRANSMISSION 02Q - GENERAL, TECHNICAL DATA (HATCHBACK))00 GENERAL, TECHNICAL DATAGENERAL INFORMATIONGENERAL REPAIR INFORMATIONFASTENERS

2012 Volkswagen Jetta TDI, 4D Sedan, Standard Trans

General Repair Information: Fasteners

2012 Volkswagen Jetta TDI, 4D Sedan, Standard TransSECTION Fasteners

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Circlip & Pliers

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Do not overstretch the circlips.
Installed position for some of the circlips: The circlip is narrower at top. This makes it easier for the pliers to grab the circlip when removing and installing it.
Always replace damaged or stretched circlips.
The circlips must fit completely inside the groove.
Replace the roll pins. Installed position: The slit -A- should align with the line of force -arrow-.

Fig 2: Identifying Locking Elements
Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.