Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2012JETTA TDI, 4D SEDAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 115 (2.0L - ENGINE ASSEMBLY - ENGINE CODE: CVCA (CONVERTIBLE))10 ENGINE ASSEMBLYGENERAL INFORMATIONSUBFRAME MOUNT, CHECKING ADJUSTMENTPROCEDURE
2012 Volkswagen Jetta TDI, 4D Sedan, Standard Trans
Subframe Mount, Checking Adjustment: Procedure
2012 Volkswagen Jetta TDI, 4D Sedan, Standard TransSECTION Procedure
WARNING: This page is about a different car, the 2015 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
The following dimensions must be attained:
- The distance -a- between the engine support -2- and the engine mount -1- must be 10 mm (0.393 inch).
- The casting edge on the engine support must be parallel to the support arm
NOTE:
Distance -a- = 10 mm (0.393 inch) can also be checked with corresponding round stock.
-- The distance measured is too small or too large, adjust the subframe, refer to SUBFRAME MOUNT, ADJUSTING .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.