Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Overview - Subframe Mount
Support engine in installed position when installing and removing
A 1) = 40 Nm + 90° additional turn.
B 1) = 60 Nm + 90° additional turn.
C 1) = 20 Nm + 90° additional turn.
1) replace
1 1) = 40 Nm + 90° additional turn.
2 1) = 60 Nm + 90° additional turn.
1) replace
A 1) = 50 Nm + 90° additional turn.
B 1) = 50 Nm + 90° additional turn.
C 1) = 100 Nm + 90° additional turn.
1) replace
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.