Right Bucket Seat Trim

2012 Volkswagen GTI (5K1) L4-2.0L Turbo (CCTA)SECTION Right Bucket Seat Trim






Right Bucket Seat Trim

The following describes removing and installing on the left side of the vehicle. Removing and installing on the right side is identical.

Removing

- Remove the front seat. Refer to => [ Front Seat ] Front Seat.

- Remove the front seat belt latch:

2-door: => [ Belt Latch, 2-door ] Belt Latch, 2-Door

4-door: => [ Belt Latch, 4-door ] Belt Latch, 4-Door

- Push the clamping pin - 1 - toward the inside and remove the clip - 2 -.

- Press tab - 3 - upward and remove trim - 4 - from seat.






Installing

- Install in reverse order of removal.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.