Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Rearview Camera System Control Module J772, Coding
-- Connect the Vehicle Diagnostic Tester.
All instructions and information on this work procedure can be found in [For engine(s) CNNA, CCTA, CBFA] General Information .
-- Select "Guided Fault Finding" in the Vehicle Diagnostic Tester.
-- Using the "Go to" button, select the "function/component selection" and the following menu options in sequence:
- Body
- Electrical system
- 01 - On Board Diagnostic capable system
- Rearview Camera System
- Functions rear view camera
- Control module, coding
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.