Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Left Rear Level Control System Sensor -G76-, WITH ADAPTIVE CHASSIS DCC
Special tools and workshop equipment required
- Torque Wrench 1331 5-50Nm VAG1331
Removing
-- Disconnect the connector.
-- Remove the bolts.
-- Remove the Left Rear Level Control System Sensor -G76-.
Installing
Install in the reverse order of removal. Note the following:
The Left Rear Level Control System Sensor -G76- lever must point toward the vehicle exterior.
-- Perform a basic setting on the adaptive chassis DCC, refer to ADAPTIVE CHASSIS DCC, BASIC SETTING .
-- If the vehicle is equipped with lane assist, then the directional stabilization assistance control module must be calibrated after performing the basic setting on the adaptive chassis DCC, refer to LANE ASSIST, CALIBRATING .
-- Perform a headlamp basic setting, refer to the vehicle diagnostic tester.
Tightening Specifications
| Component | Tightening Specification |
|---|---|
| Left rear level control system sensor to lower track control arm and subframe bolts | 5 Nm |
Special tools and workshop equipment required
- Torque Wrench 1331 5-50Nm VAG1331
Removing
-- Disconnect the connector.
-- Remove the bolts.
-- Remove the Left Rear Level Control System Sensor -G76-.
Installing
Install in the reverse order of removal. Note the following:
The Left Rear Level Control System Sensor -G76- lever must point toward the vehicle exterior.
-- Perform a basic setting on the adaptive chassis DCC, refer to ADAPTIVE CHASSIS DCC, BASIC SETTING .
-- If the vehicle is equipped with lane assist, then the directional stabilization assistance control module must be calibrated after performing the basic setting on the adaptive chassis DCC, refer to LANE ASSIST, CALIBRATING .
-- Perform a headlamp basic setting, refer to the vehicle diagnostic tester.
Tightening Specifications
| Component | Tightening Specification |
|---|---|
| Left rear level control system sensor to lower track control arm and subframe bolts | 5 Nm |
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.