Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Brake Pressure Applied (BPA) Switch
All vehicles have a single BPA switch. A BPA switch provides a backup for the brake pedal position (BPP) switch. Normally, a brakes-applied signal from the BPP switch disengages the speed control. If the BPP switch signal is lost, the BPA switch then supplies the brakes-applied signal to the speed control system. The BPA switch signal is also used in the transmission strategy and the key on engine running (KOER) selftest.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.