Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2012BEETLE BASE, 2.5L ENG VIN P, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1795 (ENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS - DTC P0218 THROUGH DTC P0581 - (EXCEPT DIESEL & HYBRID))DTC P0552: POWER STEERING PRESSURE (PSP) SENSOR/SWITCH CIRCUIT LOW
2012 Volkswagen Beetle Base, 2.5L Eng VIN P, Standard Trans
DTC P0552: Power Steering Pressure (PSP) Sensor/Switch Circuit Low
2012 Volkswagen Beetle Base, 2.5L Eng VIN P, Standard TransSECTION DTC P0552: Power Steering Pressure (PSP) Sensor/Switch Circuit Low
WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2011 Mercury Milan, 2011 Mercury Mariner, 2011 Mercury Grand Marquis, 2011 Lincoln Town Car, and 2011 Lincoln Navigator L. However, it is still accessible from the selected car via links, so may be relevant.
P0552 - POWER STEERING PRESSURE (PSP) SENSOR/SWITCH CIRCUIT LOW
| Description: | Indicates the PSP sensor input signal was less than the self-test minimum. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | View the PSP PID to monitor the PSP input. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST DT . | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.