Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2012BEETLE BASE, 2.5L ENG VIN P, STANDARD TRANSREPAIR AND DIAGNOSISELECTRICALMOTORS, SWITCHES, RELAYSOEM CONNECTOR END VIEWS (HATCHBACK) -- BEETLECONN. VIEWS ABSABS CONTROL MODULE -J104
2012 Volkswagen Beetle Base, 2.5L Eng VIN P, Standard Trans
Abs Control Module -J104
2012 Volkswagen Beetle Base, 2.5L Eng VIN P, Standard TransSECTION Abs Control Module -J104
47-Pin Connector -T47-
| Cavity | Function |
|---|---|
| 1 | Power fuse, module |
| 2 | ... |
| 3 | Auto Hold signal |
| 4 | ... |
| 5 | 5V - Vacuum sensor |
| 6 | ... |
| 7 | RR_ out optional |
| 8 | Power ignition, module |
| 9 | RL_out optional |
| 10 | ISO_K optional |
| 11 | FR_out optional |
| 12 | CAN-H signal |
| 13 | CAN-L signal |
| 14 | L_out optional |
| 15 | Auto Hold lamp input |
| 16 | Ground VS optional |
| 17 | ... |
| 18 | ... |
| 19 | ... |
| 20 | PDC1 optional |
| 21 | ... |
| 22 | ... |
| 23 | ... |
| 24 | ... |
| 25 | PDC2 optional |
| 26 | ... |
| 27 | ... |
| 28 | PDC3 optional |
| 29 | ... |
| 30 | Vacuum sensor 2 signal, optional |
| 31 | ... |
| 32 | Power ignition, module |
| 33 | Front right speed sensor ground |
| 34 | Front right speed sensor signal |
| 35 | TPMS (RKA) signal - if equipped |
| 36 | Left rear wheel speed sensor signal |
| 37 | Left rear wheel speed sensor ground |
| 38 | Brake light switch (BLS) signal |
| 39 | ESP sensor signal |
| 40 | Vacuum sensor ground |
| 41 | Vacuum sensor signal |
| 42 | Right rear wheel speed sensor ground |
| 43 | Right rear wheel speed sensor signal |
| 44 | ESP_LED optional |
| 45 | Front left wheel speed sensor signal |
| 46 | Front left wheel speed sensor ground |
| 47 | Ground, module |
Back To Overview → ABS CONTROL MODULE J104
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.