Overview - Radio Components, Rcd 310 8AE, 8AP: Notes

2012 Volkswagen Beetle Base, 2.5L Eng VIN P, Automatic TransSECTION Notes
Fig 1: Identifying RCD-310 Entry Radio System
GWWN91-11584Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Familiarity with the function and operation is needed if there are customer concerns. Refer to the Owner's Manual.

The RCD 310 radio has the following equipment characteristics:

  • 4 speaker channels, each with 20 W
  • CD player
  • Monochrome display
  • Connection for the external CD Changer -R41- (not installed in the Beetle)
  • Connection for Multimedia System Control Module -J650-
  • External Audio Source Connection -R199-
  • UHV Low (stereo input)
  • Connection for external sound amplifier (Amplifier -R12-)
  • Optional integrated Digital Radio -R147- (DAB)
  • Convenience coding
  • Optional support for the multifunction steering wheel
  • OPS (optical parking system) on the radio display
  • A/C information shown in the radio display

The CD player integrated inside the Radio -R- plays the following CD formats:

  • Audio CD
  • CD-R
  • CD-RW
  • MP3

It is not possible to play the following formats:

  • CD with 8 cm diameter
  • "Mix CDs" (CDs containing files and audio files)

The RCD 310 is equipped with OBD.

For troubleshooting, use the Vehicle Diagnostic Tester in the "Guided Fault Finding" function.

Repairing Antenna Wires

Repairing antenna wires: Refer to GENERAL REPAIR INFORMATION .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.