Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2011TIGUAN SEL 4MOTIONREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 83 (BODY EXTERIOR DTC BASED DIAGNOSTICS (B19E8 TO B19CD))00 GENERAL, TECHNICAL DATARIGHT REAR DOOR MODULEB192D - RIGHT REAR WINDOW CONTROL CIRCUIT OPENTEST STEP 3 - RIGHT REAR WINDOW DRIVER UP CIRCUIT OPEN
2011 Volkswagen Tiguan SEL 4Motion
Test Step 3 - Right Rear Window Driver UP Circuit Open
2011 Volkswagen Tiguan SEL 4MotionSECTION Test Step 3 - Right Rear Window Driver UP Circuit Open
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2014 Volkswagen Routan, 2013 Volkswagen Routan, 2012 Volkswagen Routan, 2011 Volkswagen Routan, and 2010 Volkswagen Routan. However, it is still accessible from the selected car via links, so may be relevant.
- Turn the ignition OFF.
- Measure the resistance of the right rear window driver UP circuit between the right rear window motor harness connector and the right rear door module C1 harness connector.
Is the resistance less than 10k ohms?
Yes
No
- Repair the right rear window driver UP circuit for an open.
- Perform the Body Verification Test. Refer to Body Verification Test .
| - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.