Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2011TIGUAN SEL 4MOTIONREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 83 (BODY EXTERIOR DTC BASED DIAGNOSTICS (B19E8 TO B19CD))00 GENERAL, TECHNICAL DATARIGHT REAR DOOR MODULEB192C - RIGHT REAR WINDOW CONTROL CIRCUIT HIGHNOTES
2011 Volkswagen Tiguan SEL 4Motion
B192C - Right Rear Window Control Circuit High: Notes
2011 Volkswagen Tiguan SEL 4MotionSECTION Notes
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2014 Volkswagen Routan, 2013 Volkswagen Routan, 2012 Volkswagen Routan, 2011 Volkswagen Routan, and 2010 Volkswagen Routan. However, it is still accessible from the selected car via links, so may be relevant.
For a complete wiring diagram, refer to appropriate Wiring Diagram.
- >>When Monitored:<< Whenever the window motor is operating.
- >>Set Condition:<< The right rear window driver UP circuit does not change from high to low during a window movement command.
| Possible Causes |
|---|
| Q112 RIGHT REAR WINDOW DRIVER (UP) CIRCUIT SHORT TO VOLTAGE |
| Q212 RIGHT REAR WINDOW DRIVER (DOWN) CIRCUIT SHORT TO VOLTAGE |
| WINDOW MOTOR |
| RIGHT REAR DOOR MODULE |
| - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.