Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2011ROUTAN SEREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSIS3.6L - ENGINE DTC BASED DIAGNOSTICS [CJRA] (P1128 - P2110)00 GENERAL, TECHNICAL DATAENGINEP1696 - EEPROM MEMORY WRITE DENIED/INVALIDTEST STEP 2 - PCM ODOMETER MILEAGE NOT PROGRAMMED
2011 Volkswagen Routan SE
Test Step 2 - PCM ODOMETER MILEAGE NOT PROGRAMMED
2011 Volkswagen Routan SESECTION Test Step 2 - PCM ODOMETER MILEAGE NOT PROGRAMMED
- Turn the ignition on.
- With the scan tool, attempt to perform the Program PCM Odometer function under the PCM/ECM REPROGRAMMING Procedure. Refer to Engine .
- With the scan tool, clear DTCs.
- Start the engine.
- Allow the engine to reach normal operating temperature.
- With the scan tool, select View DTCs.
Is the status Active for this DTC?
Yes
No
- The SRI mileage has been successfully programmed into the PCM. Test is complete.
- Perform the Powertrain Verification Test. Refer to Engine .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.