Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2011GOLF BASE, 2D HATCHBACK, 2.5 A, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALMOTORS, SWITCHES, RELAYSOEM CONNECTOR END VIEWS -- JETTA & GOLF WAGONCONN. VIEWS TRANSMISSIONTRANSMISSION CONTROL MODULE -J217
2011 Volkswagen Golf Base, 2D Hatchback, 2.5 A, Standard
Transmission Control Module -J217
2011 Volkswagen Golf Base, 2D Hatchback, 2.5 A, StandardSECTION Transmission Control Module -J217
52-Pin Connector -T52-
| Cavity | Function |
|---|---|
| 1 | Ground |
| 2 | Ground |
| 3 | Power, battery |
| 4 | Signal (+), Solenoid valve 10 -N283- |
| 5 | Signal (+), Solenoid valve 4 -N91- |
| 6 | Signal (-), Solenoid valve 5 -N92- |
| 7 | ... |
| 8 | Signal (-), transmission fluid temperature sensor |
| 9 | K Line, diagnostic |
| 10 | Signal, (B) |
| 11 | ... |
| 12 | ... |
| 13 | ... |
| 14 | ... |
| 15 | Signal, Solenoid valve 2 -N89- |
| 16 | Signal (+), Solenoid valve 9 -N282- |
| 17 | Signal (-), Solenoid valve 6 -N93- |
| 18 | Signal (-), Solenoid valve 3 -N90- |
| 19 | ... |
| 20 | ... |
| 21 | Signal, (BK) |
| 22 | Signal, (PA) |
| 23 | ... |
| 24 | ... |
| 25 | ... |
| 26 | ... |
| 27 | Power, switched |
| 28 | Power, switched |
| 29 | Power, shift lock solenoid |
| 30 | Signal (+), Solenoid valve 3 -N90- |
| 31 | Signal (+), Solenoid valve 6 -N93- |
| 32 | Signal (-), Solenoid valve 9 -N282- |
| 33 | ... |
| 34 | CAN L |
| 35 | ... |
| 36 | Signal, (C) |
| 37 | ... |
| 38 | Signal (+), output speed sensor |
| 39 | Signal (-), input speed sensor |
| 40 | PWM to Tiptronic switch |
| 41 | Signal, Solenoid valve 1 -N88- |
| 42 | Signal (+), Solenoid valve 5 -N92- |
| 43 | Signal (-), Solenoid valve 4 -N91- |
| 44 | Signal (-), Solenoid valve 10 -N283- |
| 45 | Signal, transmission fluid temperature sensor |
| 46 | CAN H |
| 47 | Signal, (A) |
| 48 | Tiptronic Info |
| 49 | ... |
| 50 | Signal (-), output speed sensor |
| 51 | Signal (+), input speed sensor |
| 52 | ... |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.