Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Rear Engine Mount: Installing
-- Install the engine mount (5).
-- Install the engine mount bolts (4) and tighten the bolts to 100 Nm (74 ft lbs).
-- Install the engine mount through bolt (1). Tighten the bolt to 50 Nm (37 ft lbs).
-- Install the engine mount heat shield (2) and bolts (1). Tighten the bolts to 11 Nm (8 ft lbs).
-- Remove the adjustable jack from under the engine, if necessary.
-- Lower the vehicle.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.