Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Left Engine Mount And Bracket: Installing
-- Position the engine mount bracket to the transmission.
-- Install the engine mount bracket bolts to the transmission.
-- Install the engine mount (3).
-- Install the engine mount to frame rail upper (1), and lower (2) bolts. Tighten the bolts to 50 Nm (37 ft lbs).
-- Install the engine mount bolts (1). Tighten the bolts to 95 Nm (70 ft lbs).
-- Position the heater line bracket, and install the heater line bracket bolts (2).
-- Remove the lifting devise, as necessary.
-- Connect the negative battery cable. Refer to BATTERY, DISCONNECTING AND CONNECTING .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.