Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2010ROUTAN SREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 919 (SUSPENSION SYSTEM - GENERAL INFORMATION)GENERAL PROCEDURESLEAN CORRECTION
2010 Volkswagen Routan S
Lean Correction
2010 Volkswagen Routan SSECTION Lean Correction
WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When installing a new coil spring, install a new spring with the same part number and the same spring code. Refer to the Vehicle Certification (VC) label on the driver side door.
- Measure the distance from the wheelhouse opening to the center of the wheel and tire at the same point on both sides of the vehicle.
- If the difference exceeds 10 mm (0.4 in), a lean correction is necessary.
- Remove the higher side coil spring.
- If the original coil spring exceeds the height of the new one by 10 mm (0.4 in), install the new coil spring in the vehicle. For additional information refer to FRONT SUSPENSION article for front suspension or REAR SUSPENSION article for rear suspension.
- If the original coil spring is shorter than the new one by 10 mm (0.4 in), remove the low side coil spring from the vehicle. For additional information refer to FRONT SUSPENSION article for front suspension or REAR SUSPENSION article for rear suspension.
- Compare all 3 coil springs and select the 2 most evenly matched for installation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.