Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Right Engine Mount/Bracket: Removing
-- Raise and support the vehicle.
-- Remove the belly pan.
-- Lower the vehicle.
-- Carefully position a floor jack under the engine to support.
-- Remove the ground strap (3) from upper engine mount bracket (2).
-- Remove the three bolts (1) and two nuts (5) and the upper engine mount bracket (2).
-- Remove bolts (6) and the right engine mount insulator (4).
-- If necessary, remove bolts (2 and 3) and the right engine mount bracket (1).
-- Remove the engine mount bolts (1).
-- Remove the engine mount (2).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.