Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Towing Recognition Control Module -J345
Special tools and workshop equipment required
- Torque Wrench V.A.G 1783
The towing recognition control module is installed behind the left side trim in the luggage compartment.
Removal
-- Switch off ignition, switch off all electrical consumers and remove ignition key.
-- Remove the left side trim panel inside the luggage compartment. Refer to Removal and Installation .
-- Disengage connectors -2- and disconnect them from Towing Recognition Control Module.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.