Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2009JETTA S, 4D WAGON, 2.5 M, STANDARDREPAIR AND DIAGNOSISBODY & FRAMEIGNITION SWITCH/STEERING LOCKELECTRICAL EQUIPMENT -- (A5 PLATFORM)97 - WIRINGCONTROL MODULESVEHICLE ELECTRICAL SYSTEM CONTROL MODULE J519HEADLAMP WASHERS, ADAPTING
2009 Volkswagen Jetta S, 4D Wagon, 2.5 M, Standard
Headlamp washers, adapting
2009 Volkswagen Jetta S, 4D Wagon, 2.5 M, StandardSECTION Headlamp washers, adapting
The "active time" of headlamp washer system can be adjusted variably between 0 seconds and 12.75 seconds.
- Connect Vehicle Diagnosis, Testing and Information System VAS 5051/5052 → VAS 5051 / 5052 under Vehicle Diagnostic, Testing and Information System VAS 5051 / 5052, onnecting
- Select operating mode "Guided Fault Finding"
- Enter information as prompted and press ">" to confirm.
After the DTC memory of all control modules has been checked:
- Use "Go to" button to select "Function / Component Selection"
- Select "Body (Repair Group 01; 27; 50-97)"
- Select "Electrical system int/ext (Repair Group 01; 27; 90-97)"
- Select "01 - Self-diagnosis"
- Select "Vehicle Electrical System Control Module"
- Select "Vehicle Electrical System Control Module functions"
- Select "Adapting headlamp washer system"
- Press ">" to confirm.
- Follow tester prompts
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.