Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Driver Door Control Module -J386
General Information
The Driver Door Control Module and Driver Window Regulator Motor -V147- comprise a single component and cannot be replaced individually.
If Driver Door Control Module or Driver Window Regulator Motor is to be replaced, the work procedure DRIVER DOOR CONTROL MODULE -J386-, CODING must then be performed.
Removing and installing the driver door control module -J386-, refer to DRIVER DOOR CONTROL MODULE -J386-
Code the driver door control module -J386-, refer to DRIVER DOOR CONTROL MODULE -J386-, CODING
Adapt the driver door control module -J386-, refer to DRIVER DOOR CONTROL MODULE -J386-, ADAPTING
Additional information:
- Refer to the Owner's Manual.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.