Tightening Specifications

2008 Volkswagen Eos Turbo, StandardSECTION Tightening Specifications
WARNING: This page is about a different car, the 2014 Volkswagen Passat, 2013 Volkswagen Passat, and 2012 Volkswagen Passat. However, it is still accessible from the selected car via links, so may be relevant.
Bolted Connections Tightening Specifications
- M5 4.5 Nm
Bolts and Nuts M6 10 Nm
- M7 15 Nm
- M8 20 Nm
- M10 40 Nm
- M12 65 Nm (1)
Manual transmission Refer to [For transmission(s) 0A4] Specifications[For transmission(s) 02Q] Specifications[For transmission(s) 02E] Specifications .
DSG® Refer to [For transmission(s) 0A4] Specifications[For transmission(s) 02Q] Specifications[For transmission(s) 02E] Specifications .
A/C compressor Refer to Specifications .
Subframe Refer to Special Tools .
Drive axle Refer to Special Tools .
Engine/transmission mount Refer to FASTENER TIGHTENING SPECIFICATIONS .
Particulate filter Refer to FRONT EXHAUST PIPE WITH PARTICULATE FILTER .
(1) Tightening specification for a M12 collar bolt: 75 Nm.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.