Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2008EOS TURBO, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)DRIVELINES & AXLESWHEEL HUBSFRONT SUSPENSION
2008 Volkswagen Eos Turbo, Standard
Front Suspension
2008 Volkswagen Eos Turbo, StandardSECTION Front Suspension
- 40 Front Suspension
- General Information
- Description And Operation
- Front Axle Overview
- Wheel Bearing, Lifting To Curb Weight Position
- SUBFRAME And Consoles, Securing
- Securing Mounting Bracket
- Securing Console
- SUBFRAME, Lowering
- Drive Axle Hex Bolt Connection, Loosening And Tightening
- Drive Axle Twelve-Point Bolt, Loosening And Tightening
- SUBFRAME, Stabilizer Bar And Control Arms Assembly Overview
- Identifying The Pendulum Support Bonded Rubber Bushing
- Left Front Level Control System Sensor Assembly Overview
- Wheel Bearing Assembly Overview
- Suspension Strut Assembly Overview
- Drive Axle Overview
- Drive Axle Heat Shields
- Drive Axle Assembly Overview, With CV Joint VL100
- Drive Axle Assembly Overview, With Mounted CV Joint VL107
- Drive Axle Assembly Overview, With Attached CV Joint VL107
- Drive Axle Assembly Overview, With Tripod Joint AAR2600I
- Drive Axle Assembly Overview, With Triple Roller Joint AAR3300I
- Specifications
- Diagnosis And Testing
- Removal And Installation
- Front Left Level Control System Sensor
- SUBFRAME, Without Steering Gear
- SUBFRAME, With Steering Gear
- SUBFRAME Bonded Rubber Bushings
- Ball Joint
- Control Arm With Mounting Bracket
- Control Arm With Mounting Bracket, Left Side For Vehicles With DSG Or Automatic Transmission
- Control Arm With Mounting Bracket, Right Side On Vehicles With 6-Cylinder Engine
- Control Arm Bonded Rubber Bushing
- Mounting Bracket With Control Arm Bearing
- Stabilizer Bar
- Wheel Bearing Unit
- Wheel Bearing Housing
- Suspension Strut
- Drive Axle With CV Joint
- Left Drive Axle With Mounted CV Joint
- Right Drive Axle With Mounted CV Joint
- Drive Axle With Tripod Joint AAR2600I
- Drive Axle With Tripod Joint AAR3300I
- Disassembly And Assembly
- Suspension Strut
- Drive Axle With CV Joint VL100
- Drive Axle With Mounted CV Joint VL107
- Drive Axle With Attached CV Joint VL107
- Drive Axle With Triple Roller Joint AAR2600I
- Removing Outer Constant Velocity Joint
- Installed Location Of Spring Washer And Thrust Washer On Outer Joint
- Drive Axle With Triple Roller Joint AAR3300I
- Special Tools
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.